A practical framework for identifying workplace hazards.
A hazard is something that has the potential to cause harm, injury, illness or damage.
Reporting hazards is important because it gives workplaces a chance to fix problems before they cause harm, injury, illness or damage.
Using consistent categories helps you spot patterns across hazard reports and identify where existing controls may be failing.
Use the seven hazard types below, recommended by Riskware, to classify the hazards you identify.
Think of blood and body fluids in healthcare, mould during building remediation or sewage during maintenance.
Start by identifying how exposure could occur. If workers handle used sharps, for example, a sharps container within reach at the point of use helps reduce the need to carry an exposed needle. The controls should reflect the task and the route of exposure.
Use safety data sheets where applicable and observe how the substance is used or generated. Consider whether you can remove the process, substitute a safer product, or capture airborne contaminants at the source with suitable extraction.
Review how equipment is operated, cleaned, cleared and maintained. Depending on the task, controls might include fixed or interlocked guards, physical separation of vehicles and pedestrians, or isolation and verification of hazardous energy before maintenance.
Ergonomic hazards arise when the demands of a task place strain on the body. High force, repetitive movements, awkward reaches and sustained postures can contribute to musculoskeletal injuries. A light carton can still pose a problem if a worker lifts it from floor level hundreds of times a shift.
Watch the task at its normal pace and ask workers where they feel strain. Raising the pallet, bringing stock closer or using a lifting aid can reduce the physical demands of the job.
Trace how decisions and information move between teams. Assign responsibility for critical checks, make equipment status visible and give outgoing and incoming crews time to confirm what remains unresolved.
Assess exposure under representative working conditions. Depending on the hazard, controls could include specifying quieter equipment, enclosing a noise source or shielding workers from radiant heat. Check that the control works while the job is running.
Consult workers about when and where exposure occurs. If customer aggression routinely escalates when one person staffs a service desk alone, review staffing, the layout and how quickly backup can arrive. The controls should address the conditions workers face.